If you’re looking to take your shooting practice to the next level, learning how to properly use the Par Time and Sets features on the SG Timer 2 is a game-changer. In this article, we break down how to create a complex course of fire using these functions — step by step.
📺 We recommend watching the video below for a full visual walkthrough ⬇⬇⬇.
What is Par Time?
Par time is a way to make your timer operate in a specific way.
For example, if you program a 5-second par time, after the start signal, the timer will count down to five seconds. Then, it will give you an end signal.
After that end signal, the timer will continue capturing your shots for a few seconds to register any penalty shots.
In SG Timer 2, this is called one set.
A set can end with a shot limit, a time limit, or whichever comes first. 📘 You can find the SG Timer 2 manual here.
Let’s say we want to do a Bill Drill. We will set a limit of six shots on the timer.
As you can see, once you fire six rounds, the timer will automatically beep to end the set — and the shooting session.
We name it „shooting session” because it was programmed only for one set. So, the timer considers the session complete and shows you the results.
But what if you want to run the Bill Drill 5 or 10 times in a row? Then you need to increase the number of sets. Let’s say we choose 5 sets. And of course, we’ll need some time to reset and prepare for the next run. So we add a 10-second pause.
Here’s how it works:
👉 The timer gives a start beep;
👉 You fire six shots;
👉The timer ends the set and starts a 10-second pause;
👉 Then it gives a start beep again.
This sequence repeats 5 times. This becomes one shooting session with five sets.
Because it’s a single session, all sets will be displayed in one history — so you can compare them side by side. That makes it easier to analyze things like your first shot time or splits from one set to another.
Time Limit Instead of Shot Limit
You can also use a time limit instead of a shot limit.
For example, if you want the set to end after 3 seconds, simply set a time limit of 3 seconds.
The timer will count down and give an end signal when the time is up — regardless of how many shots you fired.
This can be programmed directly in the SG Timer 2 or through the Drills app.
Advanced Setup: Customizing Each Set Individually
So far, we’ve covered the simplified par time setup, where the same sequence repeats across all sets. However, the Drills app also allows you to customize each set individually for greater control.
For example, you might set the times as follows:
⏱️ Set 3 = 10 seconds;
⏱️ Set 1 = 5 seconds;
⏱️ Set 2 = 3 seconds.
You can also configure different pause durations between sets, enabling you to create a detailed, customized course of fire.
To do this, go to Drills > Shooting Setup. The same time and shot limits apply, but you can assign different values for each set.
There are many other useful features available in the Drills app to help you optimize your training. If you haven’t explored them yet, check out this link. Or view video bellow about advanced features of Drills App.
Tags: Drills app, dry fire, par time, sg timer, SG Timer 2, Shooters global, shooting timer, shot timer
